Alpine CDA-7865R owner manual Basic Operation, Detaching the Front Panel, Initial System Start-Up

Basic Operation

PWR	BBE	8
		RESET
MODE	c	9
Detaching the Front Panel	Connectable to Remote Control Interface Box
1 Press the PWR (Power) button at least 3	You can operate this unit from the vehicle's control
	unit when an Alpine Remote Control Interface Box
seconds to turn off the power.
	(optional) is connected. For details, contact your
2 Press the (Release) button at lower left
	Alpine dealer.
corner until the front panel pops out.
3 Grasp the left side of the front panel and pull it	Initial System Start-Up
out.
	Immediately after installing or applying power to the
	unit, it should be initialized. Press the RESET switch
	with a ballpoint pen or any other pointed object.

NOTES

•The front panel may become hot in normal usage

(especially the connector terminals), this is not malfunction.

•To protect the front panel, place it in the supplied

carrying case.	Turning Power On and Off
	1 Press the PWR (Power) button to turn on the
	unit.
	NOTE
Attaching the Front Panel	The unit can be turned on by pressing any other button
	except the eject c button.
	The volume level gradually increases to the previous
1 First, insert the right side of the front panel into
	level you were listening to before the unit was turned
the main unit. Align the groove on the front panel	off. Press the PWR button for at least 3 seconds to
with the projections on the main unit.	turn off the unit.

2 Push the left side of the front panel until it locks firmly into the main unit.

2

1

NOTE

Before attaching the front panel, make sure that there is no dirt or dust on the connector terminals and no foreign object between the front panel and the main unit.

NOTE

The very first time the power is turned on, the volume will start from level 12, the BBE will be on in the tuner mode.

4-EN