Honeywell UDA2182 manual PID Tuning, PID 2 Tune Disable default

						Configuration
		Table 6-14 PID Tuning
Sub-menu	Parameter		Selection or			Parameter Definition
selection			Range of Setting
PID 1 Tune	Accutune		Enable	When enabled, the analyzer will start
PID 2 Tune			Disable (default)	controlling to the setpoint while it identifies the
				process and adjusts the Gain or Proportional
				Band (P), Rate (I), and Reset Time (D) tuning
				constants in response to setpoint changes
				and/or Process Variable disturbances.
	Fuzzy Logic		Enable	Fuzzy Overshoot Suppression minimizes
			Disable (default)	overshoot after a setpoint change or a process
				disturbance.
				The fuzzy logic observes the speed and
				direction of the PV signal as it approaches the
				setpoint and temporarily modifies the internal
				control response action as necessary to avoid
				an overshoot.
				There is no change to the PID algorithm, and
				the fuzzy logic does not alter the PID tuning
				parameters.
				This feature can be independently Enabled or
				Disabled as required by the application to work
				with Accutune.
	Use Prop Band		Enable	When enabled, Proportional band is used
			Disable (default)	instead of Gain (default).
				See “Gain or Prop Band”.
	Use RPM		Enable	When enabled, Repeat per minute is used
			Disable (default)	instead of Minutes per Repeat (default).
				See “Reset”.
	Gain or Prop Band		Gain – 0.1% to	Gain (default) – is the ratio of output change
			1000.0%	(%) over the measured variable change (%)
			PB – 0.1 to	that caused it.
			1000.0%	G =	100 %
			default = 1.000		PB %
				where Prop Band is the proportional Band (in
				%of Input Range)
				Proportional Band (Prop Band) - is the
				percentage of the range of the measured
				variable for which a proportional controller will
				produce a 100 % change in its output.
	Rate		-0.035 to 10.000	RATE action, in minutes affects the control
			default = 0.000	output whenever the deviation is changing; and
				affects it more when the deviation is changing
				faster. The amount of corrective action
				depends on the value of Gain.

January 2009 UDA2182 Universal Dual Analyzer Product Manual 97