Honeywell UDA2182 manual Auto Cycling Configuration 16 Auto Cycling Configuration, Offdefault

Configuration

6.15.3 Auto Cycling Configuration

Table 6-16 Auto Cycling Configuration

Sub-menu	Parameter	Selection or Range	Parameter Definition and Restrictions
selection		of Setting
Auto Cycle 1	Auto Cycling	Disable (default)	Allows auto cycling to be selected. This
Auto Cycle 2		Enable	should be enabled after configuration is
			complete.
	Hold Active	Enable (default)	When enabled, the output(s) sourced by input
		Disable	n for Auto Clean n is in hold during auto
			cycling.
	Probe Transit	Disable (default)	When enabled, allows probe extract and
		Enable	probe insert sequence steps to occur and
			automated probe extract and insert
			parameters are made available.
	Cycle Start Source	None or Any Digital	Starts Auto Cycle on specific Digital Signal
		Signal	selected changing from 0 to 1.
		See Table 6-4
	Extract Wait Src	None or Any Digital	Allows selection of a specific Digital Signal
	(Probe Transit =	Signal	that causes a delay in the probe extraction
	Enabled)	See Table 6-4	sequence. While the selected digital input is
			active the probe extraction will not end unless
			a timeout occurs as determined by the
			duration configured in Probe Transit Mins. If
			a source is configured, the timeout results in
			an Auto Cycle Fail. If a digital signal is not
			available, the source may be left at “None”
			and the extract step will occur for the duration
			of Probe Transit Mins.
	Insert Wait Src	None or Any Digital	Allows selection of a specific Digital Signal
	(Probe Transit =	Signal	that causes a delay in the probe insertion
	Enabled)	See Table 6-4	sequence. While the selective digital input is
			active the probe insertion will not end unless a
			timeout occurs as determined by the duration
			configured in Probe Transit Mins. If a source
			is configured, the timeout results in an Auto
			Cycle Fail. If a digital signal is not available,
			the source may be left at “None” and the
			extract step will occur for the duration of
			Probe Transit Mins.
	Cycle Interval	Off(default)	Frequency of Auto Cycle occurrence
		Monthly
		Weekly
		Daily
		Custom
	Start Time	Disable (default)	Set specific time for Auto-Cycle to start.
	(Custom)	Enable

January 2009 UDA2182 Universal Dual Analyzer Product Manual 101