Honeywell UDA2182 manual DgtlVar

Configuration

AC 2 Cal 2	Auto Cycle 2	Auto Cycle 2 digital output (Cycle Start Source) configuration selection
	Calibration Point 2	See Table 6-16 Auto Cycling Configuration.
AC 2 Fail	Auto Cycle 2 Failure	Auto Cycle 2 Failure is active whenever an Auto Cycle 2 failure occurs
		Auto Cycle 2 digital output (Cycle Start Source) configuration selection
		See Table 6-16 Auto Cycling Configuration.
Input 1 Cal	Input 1 Calibration	This signal goes TRUE when the calibration factor for input 1 is being
		calculated. The TRUE state is active for less than one second.
Input 2 Cal	Input 2 Calibration	This signal goes TRUE when the calibration factor for input 2 is being
		calculated. The TRUE state is active for less than one second.
Output 1 Cal	Output 1 Calibration	The signal indicates when the Output 1 calibration values are being
		changed. The signal goes TRUE when the “4ma Offset” or “20ma
		Offset” is being modified. The signal goes FALSE when the value is
		entered.
Output 2 Cal	Output 2 Calibration	The signal indicates when the Output 2 calibration values are being
		changed. The signal goes TRUE when the “4ma Offset” or “20ma
		Offset” is being modified. The signal goes FALSE when the value is
		entered.
Output 3 Cal	Output 3 Calibration	The signal indicates when the Output 3 calibration values are being
		changed. The signal goes TRUE when the “4ma Offset” or “20ma
		Offset” is being modified. The signal goes FALSE when the value is
		entered.
DgtlVar 1	Digital Variable 1	Initial values of Digital Variable 1 applied at power on.
DgtlVar 2	Digital Variable 2	Initial values of Digital Variable 2 applied at power on.
DgtlVar 3	Digital Variable 3	Initial values of Digital Variable 3 applied at power on.
DgtlVar 4	Digital Variable 4	Initial values of Digital Variable 4 applied at power on.

62 UDA2182 Universal Dual Analyzer Product Manual January 2009