Honeywell UDA2182 manual Relays Configuration

	Configuration
• Press	to highlight the desired menu selection then press Enter to display the

group of parameters.

Refer to “Section 6.4.1 – “General Rules for Editing”.

Table 6-7 Relays Configuration

Sub-menu	Parameter	Selection or Range	Parameter Definition
selection		of Setting
Relay Types	Type	Digital Out	Digital Output Relay (default)
Set relay		Time Prop	Time Proportional Output Relay
types first		Freq Prop	Frequency Proportional Output
		On/Off	On / Off control relay
		Pulse Out	Pulse Output
Relay 1	A Digital Output Relay allows connection to any Alarm, Control Alarm, Logic, Alarm Event,
Relay 2	Hold, Input or Output Fault, or Digital Input.
Relay 3
	Source	Any Digital Signal	Digital Source
Relay 4
		See Table 6-4
Digital Output
	Invert	Enable	Inverts the input state of the applied digital input
Relay		Disable (default)	such that inverse relay operation is achieved
Relay 1	Time proportional output is a form of a process variable transmitter or control output that
Relay 2	pulses the relay as a pulse width modulated signal that is proportional to the input signal over
Relay 3	a configured input range. The Time Proportional cycle time is configurable between 0.1 and
Relay 4	999 seconds while the duty cycle is directly proportional to the selected input signal.
Time	Source	Any Analog Signal	PV Source
		See Table 6-3
Proportional
	High Range	-99999 to 99999	The high range is the PV based engineering unit
Output Relay
		default = 100.00	value configured as the value that will produce a
			100 percent (always active) duty cycle.
	Low Range	-99999 to 99999	The low range is the PV based engineering unit
		default = 0.00	value configured as the value that will produce a
			0 percent (always inactive) duty cycle.
	Invert	Enable	Inverts the proportional range of the applied
		Disable (default)	analog input such that inverse relay operation is
			achieved.
	Cycle Time	0 to 999 seconds	Cycle time is that time period, in seconds, the
		default = 10	relay will be activated.
	Min Off Time	0 to 15	Minimum off is that time period, in seconds, the
		default = 0	relay will be activated.
	Min On Time	0 to 15	Minimum On is that time period, in seconds, the
		default = 0	relay will be activated.

January 2009 UDA2182 Universal Dual Analyzer Product Manual 77