Honeywell UDA2182 manual Outputs Configuration, Accessing Outputs Menu

Configuration

6.7 Outputs Configuration

Overview

This group lets you select the signal that will be transmitted.

Accessing Outputs Menu

•Press Setup to display the Main menu.

•Use the keys to select “Outputs” then press Enter to enter the sub-menu.

•Output 1, Output 2, or Output 3 and their associated parameters are available for selection.

•	Press		to highlight the desired menu selection then press Enter to display the
	group of parameters.
Refer to “Section 6.4.1 - General Rules for Editing”.
			Table 6-6 Outputs Configuration
Sub-menu		Parameter		Selection or Range	Parameter Definition
selection				of Setting
Output 1		Source		Any Analog Signal	Process Variable Source - Selects the signal
Output 2				See Table 6-3	that will be transmitted.
Output 3					See Note 1 for units.
		High Range		-99999.00 to 99999.00	High Range Value - value of input that
					corresponds to 100 % output value.
					See Note 1 for units.
		Low Range		-99999.00 to 99999.00	Low Range Value - value of input that
					corresponds to 0 % output value.
					See Note 1 for units.
		Slew Time		0.000 to 999.00	Slew Time is the maximum rate of change
				in seconds	required to drive the output from full OFF (0% -
				default = 0.000	typically 4 mA) to full ON (100% - typically
					20mA).
		mA Range High		0 to 20	Value of mA output that corresponds to 100 %
				default = 20	output signal (for example: 20 mA).
		mA Range Low		0 to 20	Value of mA output that corresponds to 0 %
				default = 4	output signal (for example: 4 mA).
		mA Limit High		0 to 21	Value of mA that you want to set the High
				default = 21	Range Limit.
		mA Limit Low		0 to 21	Value of mA that you want to set the Low
				default = 3	Range Limit.

74 UDA2182 Universal Dual Analyzer Product Manual January 2009