Honeywell UDA2182 manual How it works, Displays

Operating the Analyzer

5.7.3How it works

Each occurrence of a sequence of actions for the cleaning and calibration of a probe is a cycle. The status message “Auto Cycle n Active” appears for the duration of a non- failing cycle (where n refers to 1 or 2). Each cycle consists of the following sequence that will vary depending on the input type and parameters selected:

Cycle Start

Probe Extract (if enabled)

Probe Rinse

Cal pt 1

Cal pt 2 (If the input is pH)

Probe Insert (If enabled)

Resume Delay (If a time is selected)

For a more detailed explanation please refer to Table 5-5.

5.7.4Displays

The current sequence step is shown in the upper half of the Auto Cycle display.

When Cycle Stop is displayed, the field to the right displays the current clock time in the format configured in Setup/Maintenance/Clock.

When the cycle is active, the same field provides the remaining elapsed time for the current sequence step.

The lower half of the Auto Cycle display provides either: the date and time of the next cycle, an indication that the cycle timer is off; or an auto cycle fail detail message.

January 2009 UDA2182 Universal Dual Analyzer Product Manual 29