Alpine CDE-9852 owner manual Audio, Indication for CD Player, Indication for iPod Mode, 20-EN

CD

CD Player not functioning.

•Out of operating temperature range +50°C (+120°F) for CD. - Allow the vehicle’s interior (or trunk) temperature to cool.

CD playback sound is wavering.

•Moisture condensation in the CD Module.

-Allow enough time for the condensation to evaporate (about 1 hour).

CD insertion not possible.

•A CD is already in the CD player.

-Eject the CD and remove it.

•The CD is being improperly inserted.

-Make sure the CD is being inserted following instructions in

the CD Player Operation section.

Unable to fast forward or backward the CD.

•The CD has been damaged.

-Eject the CD and discard it; using a damaged CD in your unit can cause damage to the mechanism.

CD playback sound skips due to vibration.

•Improper mounting of the unit.

-Securely re-mount the unit.

•The disc is very dirty.

-Clean the disc.

•The disc has scratches.

-Change the disc.

•The pick-up lens is dirty.

-Do not use a commercial available lens cleaner disc. Consult your nearest Alpine dealer.

CD playback sound skips without vibration.

•The disc is dirty or scratched.

- Clean the disc; damaged disc should be replaced.

Error displays (built-in CD player only)

•Mechanical error

-Press . After the error indication disappears, insert the disc again. If the above-mentioned solution does not solve the

problem, consult your nearest Alpine dealer.

CD-R/CD-RW playback not possible

•Close session (finalization) has not been performed. - Perform finalization and attempt playback again.

MP3/WMA

MP3 or WMA is not played back.

•Writing error occurred. The CD format is not compatible.

-Make sure the CD has been written in a supported format. Refer to “About MP3/WMA” (page 10-11), then rewrite in the format supported by this device.

Audio

The sound is not output from the speakers.

•Unit has no output signal of the internal amplifier. - POWER IC is switched to “ON” (page 16).

Indication for CD Player

•Protective circuit is activated due to high temperature.

-The indication will disappear when the temperature returns to normal operating range.

•No CD is inserted.

-Insert a CD.

•Although a disc is inserted, “NO DISC” is displayed and the unit does not start to play or eject the disc.

-Remove the disc by following these steps:

Press the button again for at least 2 seconds.

If the disc still does not eject, consult your Alpine dealer.

•Mechanism error.

1)Press the button and eject the CD.

If not ejecting, consult your Alpine dealer.

2)When the error indication remains after ejecting, press the button again.

If the error indication still does not turn off after pressing the button for a few times, consult your Alpine dealer.

•When “ERROR” is displayed:

If that the disc cannot be ejected by pressing , press the RESET

switch (refer to page 6) and press again.

If the disc still cannot be ejected, consult your Alpine dealer.

•A copy-protected WMA file was played back.

- You can only play back non-copy-protected files.

•The disc is not written in a MP3/WMA supported format. - Use a disc written at the MP3/WMA supported format.

Indication for iPod Mode

•The iPod is not connected.

-Make sure the iPod is correctly connected (refer to “Connections”).

Make sure the cable is not bent excessively.

•The iPod’s battery remains low.

-Refer to the iPod’s documentation and charge the battery.

•There are no songs in the iPod.

-Download songs to the iPod and connect to the adapter.

20-EN