Alpine DVA-5205E owner manual When using remote control, Replacing the batteries

When using remote control

When using remote control

• Mode Switch

To operate the DVD Player, make sure the mode switch is on “DVD”. DVD operations are shown as the blue characters on the remote control unit.

DVD / AUDIO

Switching to “AUDIO” mode, makes it possible to operate Alpine audio products as well. Audio operations are shown as the white characters on the remote control unit.

•Point the remote control at the remote sensor within about 2 meter.

•It may not be possible to operate the remote control unit if the remote control sensor is exposed to direct sunlight.

•The remote control is a small, light weight precision device. To avoid damage, short battery life, operational errors and poor button response, observe the following.

-Do not apply any shock.

-Do not put in a trouser pocket.

-Keep away from food, moisture and dirt.

-Do not place in direct sunshine.

Replacing the batteries

Opening the battery cover

Push on the cover and slide it as indicated by the arrows then the cover will be removed.

Replacing the battery

Remove the old batteries. Insert new ones matching the (+) and (–) polarities as shown in the diagram inside the remote control. -

+ +

-

Closing the cover

Push the cover in the arrow direction until a click is heard.

Note: Use two AA size batteries.

Warning

DO NOT OPERATE ANY FUNCTION THAT TAKES YOUR ATTENTION AWAY FROM SAFELY DRIVING YOUR VEHICLE. Any function that requires your prolonged attention should only be performed after coming to a complete stop. Always stop the vehicle in a safe location before performing these functions. Failure to do so may result in an accident.

8