Altinex CP7317RS manual Memory, 4.10.3, 4.10. 4. MEMORY, Controllers

CONTROLLERS

33Power up status of relays on port 2,3,4. If bit is set to 0 then relay will be closed on power up. If bit is set to 1 then relay will be open on power up.

34Left bracket for beginning command code. Factory set to “[“.

35Right bracket for ending command code. Factory set to “]“.

36Power on default status of digital port 1

37Power on default status of digital port 2

38Power on default status of digital port 3

39Power on default status of digital port 4

40Not available / Do not read or write into this location.

.	.
.	.

127Not available / Do not read or write into this location.

128User programmable

.	.
.	.

255User programmable

4.10.2.MEMORY 2

I/O port / memory is B Sub-Register address is from 00 to 255

Sub-Register definitions

00	User Programmable
.	.
.	.
.	.
255	User programmable
4.10.3.	MEMORY 3

I/O port /memory is C Sub-Register address is from 00 to 255

These registers are used to feed back code for transition of input I/O pins from 1 to 0. If any of the I/O pins are designated as inputs then these pins will produce RS-232 code when shorted to ground and another code when they transition from 0 to 5 volts. The maximum feedback code

length is 8 bytes. Each pin is assigned to a location of the memory.

Sub-Register definitions

0000-7 locations for return code for port 1 pin 1 for transition from 0 to 1. This return code should include any

	necessary brackets.
.	.
.	.
.	.
07	end of return code

0800-07 locations for return code for port 1 pin 2 for transition from 1 to 0. This return code should include any

	necessary brackets.
.	.
.	.
.	.
15	end of return code

Default return code is in the following format [Px.yd]

xport number 1, 2, 3, 4

ypin number 1, 2, 3, 4, 5, 6,

7, 8

ddirection U for 0->1 or D for 1->0 transition

4.10.4. MEMORY 4

I/O port / memory is D Sub-Register address is from 00 to 255

These registers are used to feed back code for transition of input I/O pins from 0 to 1. If any of the I/O pins are designated as inputs then these pins will produce RS-232 code when shorted to ground and another code when they transition from 0 to 5 volts. The maximum feedback code length is 8 bytes. Each pin is assigned to a location of the memory.

Sub-Register definitions

0000-07 locations for return code for port 1 pin 1 for transition from 1 to 0. This return code should include any necessary brackets.

.	.
07	end of return code

13