Altinex MT105-101 manual Summary of Commands, Ver, Off, Clr, Fbd, Rsi, Rsn, Test, Help, Menu Mode

MULTI-TASKER™

7.3.SUMMARY OF COMMANDS.

Card Commands

1)	[VER]	Display software version.
2)	[C]	Display status of the card.
3)	[CnS]	Save card settings.
4)	[?]	Show system cards.
5)	[?C]	Show card information.
6)	[STA1]	Enable auto feedback.
7)	[STA0]	Disable auto feedback.
8)	[ON]	Enable outputs.
9)	[OFF]	Disable outputs.
10)	[…S]	Save the command being sent.
11)	[…F]	Show command feedback.
12)	[…P]	Set path, preload for [SW].
13)	[SW]	Switch preloaded outputs.
14)	[ImOx]	Connect an input to output.
15)	[ImO*]	Connect one input to all
		outputs.
16)	[CLR]	Reset card to default values.
17)	[FBD]	Feedback delay on/off.
18)	[RSI]	Reset Card ID’s.
19)	[SIDn]	Set all Card ID’s.
20)	[SIDnCi]	Set one Card ID.
21)	[SID+n]	Set Card ID offset.
22)	[RSN]	Read Card slot number.
23)	[TEST]	Test internal memory IC's.
24)	[MATmXy] Matrix Configuration.
25)	[HELP]	Display available commands.
Group Commands
26)	[WR] Groups multiple cards.

27)[RMC] Remove members from a group.

28)[RMG] Delete a group.

29) [RD] Displays group members.

7.4 MENU MODE

Menu mode commands are RS-232 commands that allow virtually the same functionality as programming commands. Unlike the programming commands in the previous sections, 7.2 and 7.3, Menu commands prompt the user to select from a list of available options. The system then responds based upon selections made by the user.

Menu commands may be issued in response to prompts from the communication software.

The menu driven commands are only available with Multi-Tasker™ Front Panel systems that have the following firmware:

690-0122-015 = Version 015 or later.

690-0123-004 = Version 004 or later.

690-0124-018 = Version 018 or later.

Send the command [VER], and the system will respond with feedback that includes the following:

690-0122-015 690-0123-004 690-0124-018

Check the last three digits against the numbers above to determine if the menu mode option is available.

7.4.1 MENU COMMAND DEFINITIONS

Refer to section 7.2 for details on card functions and examples. Following is a cross-reference of menu mode sections versus programming commands.

MENU	COMMAND
Control
Select	n/a
Save	[CnS]
Clear	[CLR]
On/Off	[ON], [OFF]
In-Out	[ImOX], [ImO*]
Setup
Group ID	[WR], [RMC]
Matrix Config.	[MAT]
Status	[VER], [C]
Help	[HELP]

400-0131-004 18

18