Example:
Command = [I2O*C4]
Feedback = (MA0202020202020202C04)
MA | = Matrix Settings |
0202…02 = Output connections
C04 | = Card ID |
Output Connection Description:
Reading from left to right, the first two digits are for output 1, the next two for output 2, and so on. Each two digit pair represents the input number to which each output is connected.
7.[STA0]
This command disables automatic feedback from the card and front panel. The command affects any card with
Command Format [STA0]
8.[ON]
This command will enable one or more outputs for a single card, or a group of cards.
SINGLE CARD OPERATION
Command Format: [ONmCnUi]
m= Output number (m = # from 1 to 8) Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
There is an
1)[ON1C5]: Turns on only Input 1.
2)[ON3C5]: Turns on only Input 3. Inputs 1 and 3 are now on.
GROUP OPERATION
This command enables output “m” for each card in group “k” of unit “i”.
11 |
Command Format: [ONmGkUi]
m= Output number (m = # from
Ui = Unit ID (i = # from
Example:
[ON1G1]: Turns on Output 1 for each card in Group 1. See the GROUP commands for a detailed explanation.
PATH OPERATION
This command will set the path for the output, but it is not active until the switch command, [SW], is executed. Commands ending in “P” are not executed immediately. The path for outputs on multiple cards, or the same card, may be preloaded.
Command Format: [ONmCnUiP]
m = Output number (m = # from 1 to 8)
Cn = Card ID (n = slot # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
P= Path
Example:
There are two
9.Enable Output 1 of card 6 and Output 3 of card 9 simultaneously. To do this, send the following commands:
[ON1C6P] , [ON3C9P] and [SW]
If “F” is included, use the [ONmCnPF] command or the [ONmCnFP] command.
FEEDBACK OPERATION
Command Format: [ON…..F]
After processing a command, an “OK” or “[ERR001]” will be returned as feedback if “F” is included at the end of a command string.
Example:
[ON1C2F]: if path is not set
[ON1C2PF]: if path is set
11
