Altinex MT113-102/103 manual Multi-Tasker, GkUi

MULTI-TASKER

To clear all groups of unit 1, send the [CLR GU1] command.

17. [GkUi]

This command is used to request group data. With the command, the user can identify which input or output of a particular group is on. Command Format: [GkUi]

k = group number (k = # from 1-9) i = unit number (i = # from 0-9)

Example:

If group 1 has DA Cards with output 1 and 2 on, while group 2 has SW Cards with input 2 on:

1)[G1]: will return feedback as [On12G1].

2)[G2]: will return feedback as [On2G2].

18.[RDXX]

This command reads card memory at address

XX. Command Format: [RDXXCnUi]

XX= data address (XX = # from 60-FF in hex format)

n = card ID No. (n = slot # from 1 to 19) i = unit number (i = # from 0-9)

Example:

To read memory at address 0x0A card 2 of unit 1, send the [RD0AC2U1] command. The system will return feedback as RD0A1DC2, if data at address 0x0A is 0x1D.

19. [WRXXYY]

This command writes data YY into card memory at address XX . Command Format: [RDXXYYCnUi]

XX= data address (XX = # from 60-FF in hex format)

YY= data (YY = # from 00-FF in hex format) n = card ID No. (n = slot # from 1 to 19)

i = unit number (i = # from 0-9)

Example:

To write data 0x2B into memory at address 0x10 card 5 of unit 1, send the [RD102BC5U1] command. The system will return feedback as OK.

20. [WRCn…GkUi]

14

This command groups multiple cards in the MT100-100 Enclosure. Each unit contains a maximum of nine groups.

n = card ID No. (n = slot # from 1 to 19) k = group number (k = # from 1-9)

i = unit number (i = # from 0-9)

Example:

To group card #1, 2, and 3 as group 5 of unit #1, send the [WRC1C2C3G5U1] command. After executing this command, cards 1, 2, and 3 of unit 1 will be grouped together as group 5.

21. [CLRGkUi]

This command clears the members for a single group or for all nine groups. MT113-102 Application Diagram

Command Format: [CLRGkUi]

k = group number (k = # from 1-9) i = unit number (i = # from 0-9)

Example:

To clear group #1, send the [CLRG1U1] command. This command clears the members for the specified group only.

To clear all groups of unit 1, send the [CLRG1U1] command.

22. [HELPCn]

This command displays all RS-232 commands available for user control

23. […S]

S at the end of command string will save settings immediately.

24. […F]

F at the end of the command will return feedback OK or ERROR.

14