Altinex MT115-111 manual Multitasker, STA0, 13.EQ, 14.EQ=, Gain

MULTITASKER

Feedback Prefix Definitions:

MT	Card Model Number
VR	Firmware Revision
GN	Video Gain Levels
EQ	Equalization Levels

Example:
Command =	[EQ1=1C4]
Feedback =	(EQ0132C04)
	EQ	=	Equalization
	01	=	Input 1 Equalization
	32	=	Input 2 Equalization
	C04	=	Card ID

12. [STA0]

This command disables automatic feedback from the card and front panel. The command affects all cards with auto-feedback capability, not just the MT115-111.The default at power on or reset is STA0, OFF.

Command Format: [STA0]

13.[EQ]

This command displays the equalization setting for an input and selects that input for adjustment using the [+] and [-] commands.

Command Format: [EQmCn]

m = Input # (m = 1 or 2)

Cn = Card ID (n = slot # from 1 to max slots)

Example:

Display the equalization setting for Input 1 of C4, then increase the equalization level by 3 from a starting value of 12.

Send the command [EQ1C4] and the current setting for Input 1 will be displayed.

[12]

Next, send the commands [+], [+], and [+] to increase the setting by 3. Send the [EQ] command again to receive new value.

[15]

CARD CONTROL

Card control commands allow the main functions of the card to be executed over the RS-232 bus, or from the front panel’s programmable keys.

14.[EQ=]

This command sets the equalization for an input to a value specified by the user.

Command Format: [EQm=xCn]

m = Input # (m = 1 or 2)

x= Equalization level (m = # from 1 to 64) Cn = Card ID (n = slot # from 1 to max slots) Example:

Set the equalization on Input 2 of C4 to a value of 32 by sending the command [EQ2=32C4]. The card will respond with feedback of “[ ]” once the command is executed.

15.[GAIN]

This command displays the gain setting for an input and selects that input for adjustment using the [+] and [-] commands. A gain setting of 4 is equivalent to unity gain.

Command Format: [GAINmCn]

m = Input # (m = 1 or 2)

Cn = Card ID (n = slot # from 1 to max slots)

Example:

Display the gain setting for Input 2 of C4, then decrease the gain level by 3 from a starting value of 10.

Send the command [GAIN2C4] and the current setting for Input 1 will be displayed.

[10]

Next, send the commands [-], [-], and [-] to decrease the setting by 3. Send the [GAIN] command again to receive new value.

[7]

400-0443-004 13