MULTITASKER
2.[C]
This command receives the status of the card. Command Format: [Cn]
Cn = Card ID (n = # from 1 to max slots) Example:
There is one
INPUT#1 VIDEO GAIN 4 EQUALIZATION 32 INPUT#2 VIDEO GAIN 4 EQUALIZATION 32
In this case, both card inputs are set for a video gain of 4 and an equalization of 32.
If there is no card in slot 4, sending the [C4] command will not return any feedback.
3.[CnS]
This command saves the card settings and displays the status. After the system is reset or powered off and on, the settings are restored.
Cn = card number
S = save configuration Example:
Save the status by sending [C4S]. The feedback returned will be similar to the following:
INPUT#1 VIDEO GAIN 4 EQUALIZATION 32 INPUT#2 VIDEO GAIN 4 EQUALIZATION 32
SAVED
4.[...S]
This command will save the configuration command being sent in memory. When sending the command [EQ1=16C4S], after reset or power up, the equalization for Input 1 will be set to 16.
5.[CLR]
This command clears the card settings and returns it to the factory default values. The defaults gain setting is 4 and the default equalization setting is 32 for each input.
Command Format: [CLRCn]
Cn = Card ID (n = slot # from 1 to max slots) Example:
In order to clear the card in slot 4, send the command [CLRC4]. The card will respond with the following feedback when complete:
FACTORY RESET COMPLETED
6.[TEST]
This command performs a series of tests on the internal memory and displays a pass message if successful. Otherwise, failures are indicated.
Command Format: [TESTCn]
Cn = Card ID (n = slot # from 1 to max slots)
Upon completion, the system will display the results. This feedback will be similar to the following:
MEMORY IC TEST RESULTS: MEMORY IC PASS
7.[HELP]
This command displays information available for the MultiTasker interface commands.
Command Format: [HELPCn]
Cn = Card ID (n = # from 1 to max slots) Example:
In order to display the
11 |