10

Diaphragm replacement:

1 At the present time (January 2007), diaphragms are not currently available, so you will have to replace the complete driver following the previous section (pages 6-9). If you have received a diaphragm, please follow the steps below.

2 Follow steps 1-6 of the high frequency driver replacement instructions, as the horn assembly will need to be removed in order to access the diaphragm.

1

+

42

-

3

 

3 A closeup of the high frequency driver is shown above. Four screws need to be removed from the driver using the 3mm allen wrench.

4 Keep the four screws in a safe place.

5 The diaphragm and plate adapter are easily removed from the horn assembly. They may not be broken down any further. Place the new diaphragm (part

#coming soon) and plate assembly where the old one was. Follow the same steps as above, but backwards 4 to

1. Power up the SA1530z and the new diaphragm should now be pumping out those highs again. Sweet, you just replaced a diaphragm!