12

Mid Frequency Driver replacement continued:

1

4

1

-+

2

3

Keep the four screws and locking

6 washers in a safe place.

2

4

+-

3

 

5 Four screws and locking washers may be removed from the mid frequency driver using the phillips head screwdriver. Contrary to what the picture shows, the screws are actually about 2 3/4” down from the top of the horn assembly. Also note that the screws may be tighter than usual. Please DO NOT add WD-40 or any other lubricant to help loosen the screws.

7 The mid frequency driver easily lifts right off of the horn. Replace with the new driver (part #0013897) and follow the same steps as above, but backwards 7 to 1. Power up the SA1530z and the new driver should now be pumping out those mids again. Right on, you just replaced a mid frequency driver!