Child lockout

This safety feature is used to prevent children from accidentally programming oven by disabling electronic oven control. Child lockout is also useful to prevent accidental programming while cleaning the range control. Press and hold the BAKE and CLOCK pads for 5 seconds. OFF displays where the temperature normally appears. To reactivate control, press and hold the BAKE and CLOCK pads for 5 seconds on the oven control. Child lockout must be reset after a power failure.

12-hour automatic cancel

This safety feature prevents oven from continuing to operate if it has been left on for over 12 hours. If a cooking function continues longer than 12 hours without any options on oven control being touched, this feature turns oven off. Any time an option is touched, 12-hour automatic cancel is reset.

Oven temperature control adjustment

Your range is calibrated at the factory for proper temperature. Due to individual variances and preferences, it may be necessary to adjust ovens once they have been installed.

When first using the oven, follow recipe times and temperatures. Before adjusting oven baking temperature, test a recipe by setting oven temperature higher or lower than the suggested temperature. The baking results should help you to decide how much of a temperature adjustment is required.

An accurate digital thermometer is necessary to calibrate the oven. Store purchased oven thermometers may not accurately measure oven temperature. Oven temperature can be increased or decreased by 35°F. To avoid over adjusting the oven, only adjust the temperature by 5°F each time.

NOTE: DO NOT place aluminum foil on racks and oven bottom as this will alter oven performance. Check for blocked heat vents. If it still appears the oven is not performing as expected, a calibration may be done.

1.Press BAKE pad.

2.Using the UP arrow pad until an oven temperature greater than 500°F displays.

3.Immediately press and hold BAKE pad for approximately 5 seconds.

4.A double digit offset temperature will display. Factory default is normally 00 degrees.

•Use arrow pads to key to adjust the temperature change in 5° increments.

•When temperature is adjusted to a cooler setting, a minus sign (-) will display with the offset temperature.

5.To set the temperature change, press OVEN CANCEL pad.

•Offset temperature change will be retained through a power failure.

Service codes and tones

Electronic oven control is equipped with a self-diagnostic system.

The self-diagnostic system alerts you if there is an error or problem with the unit. If electronic range control sounds a series of short, rapid beeps for over

16seconds and display shows an F-code, record the F-code shown. Some F-codes can be cleared by pressing cancel or disconnecting power to the range for at least 3 minutes. If the code continues to reoccur disconnect electrical supply to range and contact an authorized servicer.

Features

F -

 

code

Possible M eaning

 

 

F1

Shorted pad button

 

 

F2

Oven over tem perature

 

 

F3

Open circuit in oven

 

 

F4

Shorted circuit in oven

 

 

F5

Failed circuit in control

 

 

F7

Lock failure

 

 

F9

Lock failure

 

 

11