Amana ACS3350, ACS3380 Setting Surface Burner Controls, MED, Never, WHEN TO USE SETTING, attempt to light bake or broil burners (oven burners) during a power failure

Using the Range

Setting Surface Burner Controls

Burner should ignite within 4 seconds. If burner does not ignite within 4 seconds, turn control knob to OFF position and follow directions in Placing Burner Caps section.

See Delayed Ignition section in Important Safety

Information for safety warnings and procedures.

1. Push in and turn knob to LITE.

•Burner should ignite within 4 seconds.

2.After gas ignites, turn control to desired setting.

•Knobs do not have distinct ‘clicks’.

•Use HI to bring food to boiling temperatures. When food is boiling temperature setting should be reduced.

•After lighting burner do not operate for long periods of time without cookware on grate. The finish on the grate can chip without cookware to absorb the heat.

•Flame size should match the size of the pan. Do not allow flame to extend up the sides of the pan. This can cause clothing to ignite, make the handle hot, or cause burns.

3.When finished cooking, turn control to OFF position.

!WARNING

To avoid risk of serious personal injury, property damage, or fire, do not leave surface burners unattended while in operation. Grease and spillovers may ignite causing a fire.

If These Controls

Are Different From

Yours

The control descriptions are intended to show the variety of features that are available in the product line. If your range does not have all the features that are shown, it is not a mistake. The information provided applies to several of the available models.

SURFACE BURNER	WHEN TO USE SETTING
CONTROL SETTINGS
LO	Use to prepare food at less than boiling
	temperatures or to simmer.
MED	Use to maintain boiling of larger amounts of food,
	low temperature frying and to maintain correct
	pressure in a pressure cooker.
HI	Use to bring food to boiling temperatures. When
	food is boiling temperature setting should be
	reduced to LO through MED.

During a Power Outage

Although the system that lights the burners is electric, surface burners can be ignited during a power outage. Never

attempt to light bake or broil burners (oven burners) during a power failure.

1.Hold match at base of desired surface burner.

2.Push in burner control knob and turn to LITE position.

3.After gas ignites, remove match from burner and turn burner control knob to desired setting.

Adjusting Burner Flame Size

•While turning the burner control knob, watch the burner flame.

•Flame size should match the size of the pan.

•Flames that extend up the sides of the pan can ignite clothing, make the handle hot, or cause burns.

9