Operation
Converting 3-Wire to 4-Wire Power Cord
1.Remove rear wire cover.
2.Remove bottom strain relief screw and retain for further use.
3.Remove screw/hex nuts from terminal block and retain for further use.
4.Remove all
5.To install the
Level Range
CAUTION
To avoid damaging oven door, do not lift or move range by oven door handle. Glass can break.
Carefully level range using legs provided. Range must be level to cook and bake uniformly.
•Place a level on top oven rack or on range top when leveling.
•Leveling legs must extended ¼ inch to engage
Removal and Replacement of Range
1.Disconnect power to range.
2.Slide range forward.
3.Unplug range cord and place range aside.
4.Remove
5.Install
6.To reinstall range, follow instructions in Installation section of this manual.
Operating Surface Elements
WARNING
To avoid risk of serious personal injury, property damage, or fire, do not leave surface elements unattended while in operation. Grease and spillovers can ignite causing a fire.
1.Push in and turn surface element control to desired setting. (Figure 11)
•Some ranges have two indicator lights, one for elements on right side and one for elements on left side of range. When either front or rear element is on, corresponding indicator light glows.
•Smoothtop ranges can have four indicator lights. After the surface controls are turned off, the appropriate surface indicator light will continue to glow until the surface elements have cooled. The length of time each light remains on will vary. Do not expect the lights for two different heating areas to go off at the same time even if the elements were turned off simultaneously.
2.When finished cooking, turn control to OFF position.
OFF
LOHI
MED
Surface element control knobs
Figure 11
10