Amana DRS2462BB, DRSE663BC, DRSE663BW, DRS2663BB 62/87,21, 3266,%/&$86, Trouble Shooting, Water

723,&￿		3266,%/(￿&$86(￿	Trouble Shooting
ICE	WATER		62/87,21￿
Ice maker is not producing		Improper water valve was installed.	Check water connection procedure in your Installation
ice (some models-continued)			Instructions. Self-piercing and 3/16” saddle valves cause low
			water pressure and may clog the line over time. Amana is not
			responsible for property damage due to improper
			installation or water connection.
Unit is leaking water		Plastic tubing was used to complete water	Amana recommends using copper tubing for installation.
		connection.	Plastic is less durable and can cause leakage. Amana is
			not responsible for property damage due to improper
			installation or water connection.
		Improper water valve was installed.	Check water connection procedure in your Installation
			Instructions. Self-piercing and 3/16” saddle valves cause low
			water pressure and may clog the line over time. Amana is
			not responsible for property damage due to improper
			installation or water connection.
Ice forms in inlet tube to ice		Water pressure is low.	Water pressure must be between 20 to 100 pounds per
maker			square inch to function properly. A minimum pressure of 35
			pounds per square inch is recommended for units with
			water filters.
		Freezer temperature is too high.	See the controls section in your owner’s manual for
			assistance on how to adjust your controls. Freezer is
			recommended to be between 0 to 2°F (-18 to –17°C).
Water flow is slower than		Water pressure is low.	Water pressure must be between 20 to 100 pounds per
normal			square inch to function properly. A minimum pressure of 35
			pounds per square inch is recommended for units with
			water filters.
		Improper water valve was installed.	Check water connection procedure in your Installation
			Instructions. Self-piercing and 3/16” saddle valves cause low
			water pressure and and may clog the line over time.
			Amana is not responsible for property damage due to
			improper installation or water connection.
		Copper or plastic tubing has kinks.	Turn off water supply and remove kinks. If kinks cannot be
			removed, replace tubing.
		Water filter is clogged or needs to be	Change water filter.
		changed.
Dispenser water is not cold		Refrigerator has been recently installed	Allow approximately 12 hours for water in holding tank to
			chill.
		Water supply in holding tank has been
		depleted.
		Water has settle into water lines outside	Discard first glass of water and refill.
		holding tank and has warmed to room
		temperature.

21