Amana DRSE663BB, DRSE663BC How to Install the Handles continued, How to Connect the Water Supply

Installing Your Refrigerator

How to Install the Handles continued

Stainless Steel Models

1 Loosen lower door clip on refrigerator door with 1/4" hex nut driver.

2Locate predrilled hole at base of handle, and fit

hollow end of handle over lower door clip.

3 Fit other end of handle over upper door clip and slide up as far as possible.

NOTE: If top of handle does not fit over top clip, loosen lower clip further until fit can be accomplished.

4 Insert 1/4" hex nut driver into predrilled hole at base of handle and tighten screw.

5 Insert screw plug into predrilled hole, as illustrated.

6 Repeat steps 2 through 5 to install freezer handle.

To remove after initial install...

•Follow steps 2 through 5 in reverse order.

IMPORTANT: To avoid damage to unit, use a flat blade screwdriver edge wrapped in masking tape to remove screw plugs.

How to Connect the Water Supply

!WARNING

To avoid electrical shock which can cause severe personal injury or death, disconnect power to refrigerator before connecting water supply. After connecting water supply, connect power.

!CAUTION

To avoid property damage, observe the following:

•Consult a plumber to connect copper tubing to household plumbing to assure compliance with local codes and ordinances.

•Confirm water pressure to water valve is between 20 and 100 pounds per square inch. If water filter is installed, water pressure to water valve must be a minimum of 35 pounds per square inch.

•DO NOT use a self-piercing, or 3/16" (4.8 mm) saddle valve. Both reduce water flow, become clogged with time, and may cause leaks if repair is attempted.

•Tighten nuts by hand to prevent cross threading. Finish tightening nuts with pliers and wrenches. Do not overtighten.

•Wait 24 hours before placing unit into final position to check and correct any water leaks.

Materials Needed

•1/4" (6 mm) outer diameter flexible copper tubing

NOTE: Add 8' (2 m) to tubing length needed to reach water supply for creation of service loop.

A B

1 Remove plastic cap (A) from water valve inlet port (B).

•Brass nut and sleeve (see literature pack)

•Shut-off valve (requires a 1/4" or 6 mm hole to be drilled into water supply before valve attachment)

•Adjustable wrench

2Place brass nut and sleeve on copper tube end and insert tube into valve inlet port.

• Attach nut on copper tubing to valve inlet port.

6