Ice ’N Water Electronic Control Dispenser Some models

Ice ’N Water™ Electronic Control

Dispenser (Some models)

CRUSHED

CUBED

AUTOLIGHT DISPENSERLOCK

CHANGE

FILTERED ICE

LIGHT
SENSOR	FILTERED WATER

!CAUTION

To avoid personal injury or property damage, observe following instructions:

•Do not operate dispenser with freezer door open.

•Do not put fingers, hands, or any foreign object into dispenser opening.

•Do not use sharp objects to break ice.

Water Dispenser Operation

It takes approximately 1 minute after initially pressing dispenser bar before water dispenses after initial connection of water supply. Discard first 10–14 containers of water after initially connecting refrigerator to household water supply and after extended periods of nonuse.

•Dispense water by pressing sturdy wide mouthed container against water dispenser bar.

Note: If water dispenser is active for more than 5 minutes, an automatic lock out sensor will shut down power to dispenser area. See Automatic Lock Out for further information.

•Stop water dispensing by releasing pressure on bar. A small amount of water may continue to fall. Spill shelf is not self-draining. Large spills should be wiped dry.

Ice Dispenser Operation

!CAUTION

To avoid property damage, do not dispense ice directly into thin glass, fine china, or delicate crystal.

•Select cubed or crushed mode by pushing the button on the dispenser panel. A green indicator light above the button indicates the current selection. Dispense ice by pressing wide-mouthed container against ice dispenser bar. Selection mode may not be changed while ice dispenser is in operation.

Important

Reduce spraying of crushed ice by holding wide mouthed container directly under ice chute and as high as possible in dispenser area.

If dispensing ice continuously, dispenser motor is designed to shut off after 3 to 5 minutes. Motor resets after 3 minutes and dispensing can continue.

A slight delay occurs when switching between cubed and crushed modes. Pieces of crushed ice will vary in size and shape. "Snow" may form on door and ice chute when repeatedly dispensing crushed ice. Allow "snow" to evaporate or wipe dry.

Taste and Odor

Observe the following to minimize taste and odor difficulties:

•Wrap foods in tightly sealed containers or moisture proof bags.

•Contact local water treatment company for specialized help if difficulties persist.

•If refrigerator has a water filter replace water filter cartridge, see Water Filtration System Installation and Operating Instructions for replacement procedure.

Dispenser Light

A light activates at full power when dispensing ice or water at full power. A light sensor automatically activates light at half-power when light levels in refrigerator area are low. Activate or deactivate sensor by pushing AUTO LIGHT button located on control façade. A green indicator light above the button indicates the sensor is active.

Dispenser Lock

This feature prevents operating both the water and ice dispenser. To activate or deactivate lock, press and hold DISPENSER LOCK button for 3 seconds. A green indicator light above the button indicates the dispenser is locked.

Automatic Lock Out

The automatic lock out feature shuts down the ice and water mechanisms of the dispenser when either mechanism has run continuously for 5 minutes. To return power to the the dispenser, press and hold the DISPENSER LOCK button for 3 seconds.

Filter Light

The filter indicator light serves as a reminder to replace the water filter. A green light indicates that the filter is in good condition. A red light indicates that the filter should be replaced. Once the light turns red, it will remain red until it is reset.

To reset indicator light, press both the DISPENSER LOCK and AUTO LIGHT buttons simultaneously for 4 seconds. The green indicator light will flash 3 times when a reset has successfully occurred.

IMPORTANT: Filter status should be reset whenever filter is replaced.