Temperature-Controlled Beverage Chiller™ (Some models)
IMPORTANT
For proper operation of Beverage Chiller™, one of the cold air intake holes must line up with notch in right door dike.
Beverage Chiller™. Air inlet is located on interior wall of refrigerator door.
Beverage Chiller™ control is located on left front wall of refrigerator section. Control adjusts amount of air circulating in Beverage Chiller™. Turn control to COLD for normal refrigerator temperature and to COLDER for colder temperature.
A
A
E
D
C
A
B
B
D
E
C
B |
|
|
C |
|
|
D |
|
|
A. Beverage Chiller™ temperature | C. | Beverage Chiller™ door |
control | D. | Air inlet |
B.Turn control clockwise for colder
Beverage Chiller™ flip top design
Beverage Chiller™ comes in a flip top and a roll top design. It is adjustable to accommodate storage and cleaning needs.
To remove Beverage Chiller™ perform the following steps:
1.Grasp Beverage Chiller™ by sides lift up and pull out to remove.
Note: If Beverage Chiller™ has a separate bottom section, remove by pushing up and pulling out.
A
A.Beverage Chiller™ bottom section Beverage Chiller™ flip top design
To replace:
1.Slide Beverage Chiller™ bottom between desired shelf rails in door liner and push down into place.
•If Beverage Chiller™ door track is cleaned, door track must be lubricated with petroleum jelly for proper operation of chiller door.
2.Slide Beverage Chiller™ between desired shelf rails in door liner and push Beverage Chiller™ top down into place over Beverage Chiller™ bottom.
A. | Door liner shelf rail | C. | Flange |
B. | Notch in door dike must line up | D. | Beverage Chiller™ |
| with one of Beverage Chiller™ | E. | Beverage Chiller™ Door |
| cold air intake holes. |
|
|
Beverage Chiller™ roll top and flip top designs
•Remove Beverage Chiller™ cover (flip top model only) by opening cover. Push cover inward at pivot points and pull cover out. Replace cover by reversing procedure.
A
B
A. | C | C. Beverage Chiller™ |
Beverage Chiller™ top | ||
B. | Beverage Chiller™ cover | bottom |
Beverage Chiller™ flip top design
Door Buckets and Shelves
Graphic below does not represent all available bucket and shelf designs, however the following instructions do apply to
all units.
Door buckets adjust to meet individual storage needs.
•Remove door buckets by pushing bucket up and pulling out.
•Replace door buckets by sliding bucket in between shelf rails and pushing door bucket down into place.
9
