Grounding Instructions | Installation |
WARNING
To avoid the risk of electrical shock or death, this equipment must be grounded.
WARNING
To avoid the risk of electrical shock or death, do not alter the plug.
This equipment MUST be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This oven is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.
Consult a qualified electrician or servicer if grounding instructions are not completely understood, or if doubt exists as to whether the equipment is properly grounded.
Do not use an extension cord. If the product power cord is too short, have a qualified electrician install a
Unpacking Equipment
•Inspect equipment for damage such as dents in door or dents inside oven cavity.
•Report any dents or breakage to source of purchase immediately. Do not attempt to use oven if damaged.
•Remove all materials from oven interior.
•If oven has been stored in extremely cold area, wait a few hours before connecting power.
Equipment Placement
•Do not install equipment next to or above source of heat, such as pizza oven or deep fat fryer. This could cause microwave oven to operate improperly and could shorten life of electrical parts.
•Do not block or obstruct oven filter. Allow access for cleaning.
Radio Interference
Microwave operation may cause interference to radio, television, or similar equipment. Reduce or eliminate interference by doing the following:
•Clean door and sealing surfaces of oven according to instructions in “Care and Cleaning” section.
•Place radio, television, etc. as far as possible from oven.
•Use a properly installed antenna on radio, television, etc. to obtain stronger signal reception.
NEMA
RFS9*
RFS11*
5
