ELECTRONIC OVEN CONTROL
A B C D E F G
L | K | J | I | H |
A. Oven light |
|
| G. Off/cancel |
|
B. Clock |
|
| H. Temp/time |
|
C. Bake indicator light |
| I. Broil |
| |
D. Display |
|
| J. Bake |
|
E. Timer indicator light |
| K. Broil indicator light | ||
F. Start (control lock) |
| L. Timer set/off |
| |
Display
When power is first supplied to the appliance, a flashing time will appear on the display. Press OFF/CANCEL to clear flashing time from the display.
If flashing time appears, a power failure has occurred. Press OFF/CANCEL and reset the clock if needed.
When the oven is not in use, the display shows the time of day.
When performing a cook or timer function, the display will show either hours and minutes, or minutes and seconds.
Oven Indicator Lights
The indicator lights are located on both sides of the display. The indicator lights light up or flash when the oven is in one of the following modes: Bake, Broil or Timer.
Start
Start begins any oven function. If Start is not pressed within 5 seconds after pressing a function pad, the Push to Start (“PSH”) indicator light will flash and the push to start tone will sound as a reminder.
If Start is not pressed within 1 minute after pressing a function pad, the oven display will return to the time of day mode and the programmed function will be canceled.
Off/Cancel
Off/Cancel stops any function except the Clock, Timer and Control Lock.
Clock
This is a
To Set:
Before setting, make sure the oven and Timer are off. Press OFF/ CANCEL to cancel the oven, and press TIMER SET/OFF twice to cancel the timer.
1.Press CLOCK.
2.Press the TEMP/TIME “up” or “down” arrow pads to set the time of day.
3.Press CLOCK or START.
Tones
Tones are audible signals, indicating the following:
One tone
■Valid pad press
■Oven is preheated (long tone)
■Function has been entered
Three tones
■Invalid pad press
■Push to start reminder
Cycling tones
■End of cycle
Fahrenheit and Celsius
The temperature is preset at Fahrenheit, but can be changed to Celsius.
To Change: Press and hold BROIL for 5 seconds. A tone will sound, and “C” will appear on the display. Repeat to change back to Fahrenheit. To exit mode, press OFF/CANCEL or wait 3 seconds.
7
