3 Power Cord—Connect remaining wires
NOTE: Do not
Connect wires black to black and white to white, using UL Listed/CSA Approved
Wiring configuration
Power supply wire: |
| Terminal box wire: |
white |
| white |
| ||
black |
| black |
| ||
ground wire |
| ground connector |
|
If needed, see website for animated representation of this step. Visit www.amana.com under FAQ tab.
4 Power
on conduit connector
Tighten strain relief screws to secure cord.
12
5 Power Cord—Reinstall terminal box cover
Place wires inside terminal box. Insert tabs on
left side of cover. Make sure wires are tucked inside box. Close cover ensuring wires are not pinched. Use ¹⁄₄” nut driver and previously removed screw to secure cover.
NOTE: Do not plug into outlet until instructed.
Determine Cabinet Opening
1 Measure cabinet opening
Measure height of cabinet opening from underside of countertop to floor where dishwasher will be installed (you will need to measure the lowest point on the underside of the countertop and the highest point on the floor). Refer to “Dishwasher Height Adjustment Chart” for wheel position and the number of turns needed.
Dishwasher Height Adjustment Chart
Cabinet | Wheel | Number of turns |
|
opening height | position | on front leg | |
|
|
|
|
33⁷⁄₈" (86.0 cm) | Removed | All the way up | |
|
|
|
|
34" (86.4 cm) | 1 | 10 |
|
|
|
|
|
34¹⁄₄" (87 cm) | 2 | 5 |
|
|
|
|
|
34¹⁄₂" (87.6 cm) | 3 | 0 |
|
|
|
|
|
NOTE: If the minimum cabinet opening height is less than 34”(86.4 cm), the rear wheels can be removed for additional clearance. This will allow the dishwasher to fit into a 33⁷⁄₈”
(86 cm) high cabinet opening, but the dishwasher will be more difficult to move. (Measurements are approximate. Wheels and legs are preset at the factory for 34¹⁄₂” [87.6” cm].)
