Amana W10261420A installation instructions Move Dishwasher into Cabinet Opening

2 Adjust wheels and legs

3 2 1

Turn both leveler legs to the same height. Put wheels in the required position determined from “Dishwasher Height Adjustment Chart”. (To change wheel position, use a flat-blade screwdriver to pop out the wheel, then snap into the new position.)

3 Built-up Floors — Add shims as needed

Move Dishwasher into Cabinet

Opening

1 Stand dishwasher upright

Using two or more people, stand dishwasher upright.

NOTE: Do not install kickplate until instructed.

2 Move dishwasher close to cabinet opening

				2
			(5		"
					cm)
"	)
4	cm
.1
(10
			"
		³⁄₄		)
	2		cm
		(7

Drain

hose

Water line

Cable

Direct Wire

only

Built-up floors (Kitchen floor height is higher than cabinet opening.) Example: Kitchen floor tile does not extend into cabinet opening. Add shims as needed in the area shown to bring the dishwasher up to 34” (86.4 cm) below the countertop.

NOTE: Shims must be securely attached to floor to avoid movement when the dishwasher is in use.

IMPORTANT: Double check correct placement of utilities. Grasp the sides of the dishwasher at the edges of the door panel. Tilt dishwasher backward on wheels and move dishwasher close to cabinet opening.

NOTE: Do not push on the front of the panel or on the console– they may dent.

Helpful Tip: Temporarily tape utilities to the floor in the locations shown to keep them from moving when dishwasher is moved into the cabinet opening.

3 Check water and drain hose position

Check that water line is on the left side of opening and drain hose is near the center of the cabinet opening.

13