13
If you experience Possible Causes Solution
Normal washer operation. Lid must be closed for washer to run.
Washer will pause during certain phases of cycle. Do not
interrupt cycle.
Washer may be stopped to reduce suds.
The washer senses the dry load with short spins that may take
2 to 3 minutes before water is added. You may hear the hum of
the spins. This is normal.
Washer won’t run or ll,
washer stops working,
or wash light remains
on (indicating that the
washer was unable to
ll appropriately)
Check for proper water supply. Both hoses must be attached and have water owing to inlet
valve.
Both hot and cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water ow.
Plug power cord into a grounded 3-prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Check proper electrical supply.
Washer may be tightly packed. Remove several items, rearrange load evenly around the
washplate. Do not load garments directly over the center of the
washplate. Close lid and press START/Pause/Unlock Lid.
Add only 1 or 2 additional garments after washer has started.
Not using HE detergent or using too
much HE detergent. Only use HE detergent. Suds from regular detergents can slow
or stop the washer. Always measure detergent and follow
detergent directions based on your load requirements.
To remove suds, cancel cycle. Select RINSE & SPIN. Press
START/Pause/Unlock Lid. Do not add more detergent.
First try the solutions suggested here or visit our website at www.amana.com/help
for assistance and to possibly avoid a service call.
Washer not performing as expected (cont.)
Do not add more water to the washer.
TROUBLESHOOTING