4.Installing the XOi
The XOi is designed to be placed on a shelf or in a component rack. If you are mounting the XOi with other components,you should remove the feet.
The audio sources are plugged into the four local source inputs on the back panel of the XOi using stereo RCA cables, Fig.4
Source 1 | Audio |
Tuner 1 | Out |
|
5.IR Outputs
The XOi system ships with four IRE1 IR Emitters for transferring IR data from the keypad receivers (located under the volume button) to the IR receiver on each piece of source equipment. There are two separated IR output sections on the back panel. The 38KHz outputs are used for most audio sources. The exception to this is cable and satellite boxes, which operate at a higher IR carrier frequency closer to 56Khz.It is important that the output being used for each source matches the source input number. The outputs work individually with each source to allow independent source control. Simply plug the IRE1 IR emitter into the appropriate IR output on the back of the XOi and attach the flasher end over the IR receiver of the source equipment, fig. 5
Fig. 5
10
