Chapter 3. Installing a Battery Backup Unit
23 3ware 9690SA SAS/SATA RAID Controller Installation Guide
Replacing the Battery
The Battery Backup Unit (BBU) will last for many years. The
battery has an expected life span of one to two years depending on
usage.
You can check the current status of the battery, and test it. For
details, see instructions in 3ware SAS/SATA RAID Software User
Guide, Version 9.5.
To replace the battery
1Make sure the system is powered down, that you are grounded,
and follow all appropriate safety procedures.
2Disconnect the battery power cable from the BBU control
module on the controller card.
To do so, press down on the lever-like clip on the battery power
connector and slide it out of the slot.
(If desired, you can remove the BBU control module to
facilitate disconnecting the power cable. This will require
removing the controller card from your enclosure.)
Caution: There is a risk of explosion if the battery is replaced
by an incorrect type. To obtain a replacement battery module,
contact AMCC.
For proper battery disposal resources, contact RBRC, the
Rechargeable Battery Recycling Corporation (www.rbrc.com).
Vorsicht: Es entsteht Explosionsgefahr bei Auswechslung der
Baterie mit einer des falschen Typs. Um eine Ersatzbaterie zu
erhalten, wenden Sie sich an die AMCC.
Um Ressourcen zur korrekten Entsorgung der Baterie in
Erfahrung zu bringen, wenden Sie sich an die RBRC (the
Rechargeable Battery Recycling Corporation) (www.rbrc.com).