Installation
Window Kit Installation
This unit is a portable air conditioner. It can be moved from room to room so that the cooling can follow you anywhere. Fitting the exhaust hose is easy, through a window or wall.
Please refer to either of the following ways:
Installation
Mounting the exhaust pipe
•The supplied exhaust hose can be extended from 1 foot to 5 feet
for mounting. It is recommended that
you use the shortest possible length of hose.
•Take care to prevent any kink or bend in the middle of the exhaust hose, as this will trap hot exhaust air, which will radiate back into the room.
1.Push out the
2.Insert the Round Connector (part #14) through the
3.Extend one end of the exhaust pipe (part #11) and screw into the Round Connector by turning clockwise.
4.Place and insert the foam strip into your window frame and close window to hold foams in place.
5.Extend other end of exhaust pipe and screw in Adaptor (part #10) by turning clockwise.
6.Push Adaptor to fit firmly over the opening on the back of the unit.
WARNING!
The length of the exhaust pipe is specially designed according to the specification of this product.
Do not replace or extend it with your own hose as this could cause the unit to malfunction.
Cleaning the Filter
Wall Connection
1.Make a hole (5.1" in diameter) in the wall.
2.Insert the Round Connector (part #14) into the hole and hold in place by using 4 small screws (not supplied).
3.Extend one end of the exhaust pipe (part #11) and screw into the Round Connector by turning clockwise.
4.Extend other end of exhaust pipe and screw in Adaptor (part #10) by turning clockwise.
5.Push Adaptor to fit firmly over the opening on the back of the unit.
**When not in use, cover the Round Connector and hole with Cap (part #15).
Use a vacuum cleaner or tap the filter lightly to remove loose dust and dirt from the filters and then rinse them thoroughly under running water (no hotter than 104ºF)
Dry thoroughly before replacing.
Notice! Never operate the unit without the filters.
6 | 7 |