Operation - Electronic Control Models
Control Panel | Cool | Set Temp. | Low Fan | Timer |
Fan Only |
| Room | High | Not available |
| Auto Temp. | Fan | on all units Power |
Mode:
AC or Fan
Temp. Up
Temp. Down | Timer | |
On / Off | ||
|
Parts
Fan Speed:
High / Low
Setting Mode/Function
Not available on all units
Press the MODE button to select the required working mode:Automatic, Cooling, Fan or Heating (Heating is only available for
The indicators of the functions in progress come on at the same time, e.g. Cool and Lo = Cooling mode with Low fan speed.
Auto Mode
When this mode is selected, the unit is preset to the following temperature settings and unit will only start to:
•Cool when room temperature is higher than 75ºF
•Heat when room temperature is lower than 68ºF
If room temperature is between 68ºF and 75ºF, unit will stay in Fan mode. Again, when in Auto Mode, the temperature settings cannot be changed.
Setting the Temperature in Cooling or Heating Mode
The display window’s default is to display the ambient room temperature. The green indicator light under RT is on. (RT = Room Temperature)
To set your desired temperature, press the Temperature up or down buttons (ranging from 64ºF to 90ºF). Each press will increase or decrease your set temperature by 1ºF. When pressing the temperature up or down buttons, the window will change to display your set temperature.At this time, the green indicator will light under ST (Set Temperature). Once the temperature up or down buttons is released, the window will return to displaying the ambient temperature after a second.
Note: When unit is in the following modes: Auto, Cool, or Heat - the compressor will cool/heat the room to reach the set temperature. Once the ambient temperature has reached the set temperature, the compressor will stop and unit will run in Fan mode. To conserve energy, the compressor will not start immediately after a couple degrees
1. | Control Panel | 5. | Air Filter |
2. | Cooling Air Outlet | 6. | Air Inlet |
3. | Handle | 7. | Exhaust Air Outlet |
4. | Castors | 8. | Cord Hanger |
|
| 9. | Water Stopper (Rubber Plug Inside) |
Accessories
10. | Adaptor - for insertion over the | 13 |
| hose and into the back of the |
|
| air conditioner | 10 |
|
| |
11. | Exhaust Hose | 12 |
|
|
12.Foam Strip - for filling the open window space and with a hole for
connection to the exhaust hose | 11 |
|
13.Foam Strip - for filling the open window space
increase or decrease, but will wait for a 5ºF allowance. For example:
In Cooling Mode with a set temperature of 70ºF
When compressor first stops after reaching 70ºF, unit will
Compressor will start cooling again when ambient temperature increases to 75ºF or above.
In Heating Mode with a set temperature of 72ºF
When compressor first stops after reaching 72ºF, unit will
In Auto Mode (with preset temperature of 68ºF for heat and 75ºF for cool)
Compressor will start cooling again when ambient temperature reaches above 80ºF or will start heating when ambient temperature drops below 63ºF.
14.Round Connector - to be used between hose and window kit or between hose and wall
15.Cap for Round Connector
16.Remote Control
(Electronic control models only)
14
15
16
8 | 5 |