Power Requirements
Your IL30/IL40 is powered by a 9V battery (not included). Install a 9V battery in the battery compartment prior to operation.
NOTE: Insert the battery with the
(+)side going between the guard posts in the battery compartment. The
the top. Installing the battery im- properly will cause damage to the
unit and will void all warranties. Please make specific note to the installation of the battery.
Important: Before replacing the battery, make sure to disconnect the IL30/IL40 from the telephone.
Installation
1.Unplug the handset cord from your telephone base. Insert this cord into the jack marked “HANDSET” located at the front of the IL30/IL40 Amplifier.
2.Plug one side of the short phone cord (included) into the jack marked “BASE” on the back of the Amplifier.
3.Plug the other side into the telephone
base (See Figure 2). | Figure 2 |
4.Set the Compatibility Switch to the “N” setting. This
setting provides compatibility for most telephones. (See Figure 1)
5.Pick up the handset. If you hear a dial tone, your IL30/IL40 Amplifier is installed properly.
If you do not hear a dial tone or the person you are calling cannot hear you, consult the Troubleshooting Guide on page 5.