Sterling 882, 0, 238 manual Installation & Setup, Safety Considerations, Necessary Tools

4 Installation & Setup

4-1 Safety Considerations

;Connect the hopper loader to a grounded three-prong power receptacle. If this is not possible, ground the hopper loader motor for electrical isolation and protection from electric shock.

;Do not use hopper loaders in explosive atmospheres.

;Do not use outdoors or in wet environments. Moisture damages the motor and can create an electric shock hazard.

;Operate hopper loaders at the rated voltage. Operation at other than design voltage can result in, at best, poor performance, and can cause damage to the vacuum motor, control, and personnel.

4-2 Necessary Tools

;Hand drill

;Pop-rivet gun

;3/16” (about 4.8 mm) -diameter rivets

4-3 Mounting Powder Hopper Loaders

Important! You can mount your powder hopper loader directly to the processing machine by cutting a hole in the machine bin lid and fastening the hopper loader to it. The hopper loader mounting flange mates with ACS equipment and uses the same mounting holes as previous ACS models.

For new installations or mounting on other manufacturer’s equipment, a hole location template is included in the information packet.

Page 24 Powder Hopper Loaders