Operation
#//, | 7!4%2%& |
&!. | |
,/7 ()'( | |
/./&& | |
&!. | |
30%%$ | |
50 | $/7. |
1. ON/OFF
Press the
2. Setting the Timer
Press the TIMER button, which will start the timer counter function.
Each press of the timer button will advance the timer setting by 1 hour, for setting
When the set hours have elapsed, the unit will turn off automatically.
The display will show the hour(s) remaining when you press the TIMER button.
By pressing the TIMER button but without turning the unit on, you can
3. Setting the Operating Mode
Select the required operating mode: COOL, FAN, or AUTO. The corresponding LED will lit. In AUTO mode the unit will select cooling or fan depending on the ambient temperature.
4. Fan Speed
Select the fan speed, the corresponding LED will lit: LOW or HIGH.
5. Increase UP or DOWN
When the unit is ON, the display always shows the room temperature. Press button UP or DOWN to see the current set temperature and adjust if necessary, in the range of 62ºF to 90ºF. After 8 seconds, the room temperature will be displayed. Use these buttons to adjust the timer.
Warning lights COMPRESSOR and WATER FULL
When the water container is full, the unit automatically stops, the warning light
will flash to signal that the container must be emptied (see page 9, “Emptying The Water Container”).
When the unit is cooling, the compressor light will be on. If this light is off further cooling is not needed at this time, or the compressor may be
The fan can still be on.
Operation
Remote control
The air conditioner responds to all signals that are sent by the remote control. Two
Note: the air flow direction can not be adjusted with the remote control.
Air flow
Adjust the
Adjust the up/down air flow by rotating the air outlet grill.
Important:
•The compressor will start approximately 3 minutes after the unit is turned on (this will help prolong the life of the compressor). After switching the unit off, please wait at least 3 minutes before turning the unit back on.
•The compressor will switch off when the room temperature is lower than the set temperature. The fan will however continue to work. When ambient temperature rises above the set temperature, the cooling will resume.
7 | 8 |