Emptying The Water Container
This portable AC features the
Innovative AutoDrain NanoMist Technology™
Very little excess water should accumulate. During the process of cooling, some of the water accumulated is actually used to cool the unit internally, making it run more efficiently. Both this evaporative technology and Innovative AutoDrain NanoMist Technology™ are features not found in most portable air conditioners.
Switch off the unit and remove the plug from the outlet.
•Position a flat container or dish on the floor under the drain hole. Do not allow the water to drip continuously into the container as it might easily overflow.
•Remove the drain knob.
•Remove the rubber plug, the water will flow in the container. When this is nearly full, replace the plug to stop the water flow and empty it. Repeat this process until all water has been removed.
• | Replace the rubber plug into the drain hole firmly, | Rubber plug | Drain knob |
| the WATER FULL LED should not flash any longer. |
|
|
• | Replace the drain knob. |
|
|
Cleaning
Always unplug the unit from the power supply (wall outlet) before beginning the cleaning.
Housing
Use a soft, damp cloth to wipe the body clean. Never use strong chemicals,
Filter
Use a vacuum cleaner or tap the filter lightly to remove loose dust and dirt from the filters and then rinse them thoroughly under running water (not warmer than 104°F).
Dry thoroughly before replacing.
Notice! Never operate the air conditioner without the filters.
Installation of Carbon Filter
It is recommended to replace an active carbon filter at the start of the season.
• Remove the top filter frame from the unit by pulling it out.
•Separate the fixer from the filter frame.
•Insert the active carbon filter into the
filter frame, underneath the tabs.
•
9 | 10 |