American Audio DCD-PRO1000 B. REMOTE CONTROL

pitch (if any) that is being applied to the track.

29. BANK BUTTONS 1-3 - These button are

used to store either three (3) cue points or three

(3) samples. Each Bank Button can store either

a sample or a cue point. 6 sec. samples each

bank.

30. SAMPLER BUTTON - This is used to acti-

vate the sampler function. When this function

is activated a created sample will play in a con-

tinuos loop, until the sampler is deactivated.

31. MEMORY BUTTON - This button allows you

to program up to 3 cue points or three samples

in to the three FLASH BUTTONS (29). The sam-

ples or cue point can then be recalled at any

time even when the disk has been removed and

reloaded at a later time.

32. PLAY/PAUSE BUTTON - Each press of the

PLAY/PAUSE BUTTON causes the operation to

change from play to pause or from pause to play.

While in play mode the green play L.E.D. will

glow, and while in pause mode the green play

L.E.D. will flash.

33. CUE - Pressing the CUE button during play-

back immediately pauses playback and returns

the track to the last set cue point (see setting a

CUE POINT, page 18). The red CUE L.E.D. will

glow when the unit is in cue mode The L.E.D. will

also flash every time a new CUE POINT is set.

The CUE button can be held down to momen-

tarily play the CD. When you release the CUE

button it instantly returns to the CUE POINT. You

can also tap the CUE button to create a BOP

GENERAL FUNCTIONS AND CONTROLS (Cont.)

©American Audio® - www.americanaudio.us - DCD-PRO1000™ Instruction Manual Page 12

EFFECT (for definition of BOP EFFECT, see page

24).

34. LCD DISPLAY - This high quality LCD display

indicates all the functions, as they are occurring.

This display is viewable at several comfortable

angles (see page 8). The display ICONS will be

explained on page 15.

B. REMOTE CONTROL - REAR

35. CHANNEL 1 REMOTE JACK - Connect the

supplied 8 pin din cable from this jack to the play-

er's channel 1 remote connector. This will allow

you to control the functions of player 1.

36. CHANNEL 1 CONTROLLER JACK - Connect

the supplied mini-plug from the CUE jack on the

rear of your CD unit to the CONTROL out jack of

a compatible American Audio® or American DJ®

mixer. This will enable the CD "Q-Start" function.

This feature is only available on American Audio®

or American DJ® “Q” series mixers.

37. CHANNEL 2 REMOTE JACK - Connect the