Set Up
INPUTS - The V4000plus amplifier allows you to use two types of input connector per a channel, a XLR jack for balanced connections and a 1/4” female jack that will accept balanced and unbalanced connectors. Use these connections to connect the output signal from a mixer,
Male XLR Pin Configuration:
US ITT Standard
31
Balanc | RS 1/4” Plug | Unbalan | TS 1/4” Plug |
2
Diagram 3
| ram 4 |
| ram 5 |
Hot (+) Ground/Shield | Hot (+) |
3 Negative (- data) 1 Ground/Return/ 0v)
2 Hot (+ data)
Negative | Negative |
OUTPUTS:
Binding Post/Banana Plug - Connect your speakers to the binding post outputs on the rear of the amplifi er. The speaker wire may be connect by bare wire (directly connected, usually for permanent connections), banana plug, or spade connector. Connections are made to Channels 1 and 2 output’s for stereo mode or across the red termi- nals of Channels 1 and 2 for Mono Bridge Mode.
Important Notice: Although a speaker will operate with the positive and negative leads plugged into either termi- nal on the amplifi er binding post, be sure to plug the negative lead into the black terminal and positive lead into the red terminal. Ensuring proper polarity will avoid speakers being out of phase, that can cause a loss of bass
response.
Diagram 8
Important Notice: Banana Plugs - When connecting your speakers to the amplifi er using banana jacks; Be sure that the red and black caps on the binding post are completely screwed in. Insert the banana jacks into the caps of the binding post, be sure that the banana jack is inserted securely to avoid the risk of it popping out.
©American Audio® - www.americandj.com - V4000plus™ Power Amplifier User Manual Page 7