Manuals
/
American Dryer Corp
/
Laundry Appliance
/
Clothes Dryer
American Dryer Corp
D20, CG20, SL20, STI-8, AD-20 manual Service Procedures for the Model 20 Dryers
Models:
AD-20
1
1
16
16
Download
16 pages
36.72 Kb
1
2
3
4
5
6
7
8
<
>
Install
Tumbler Support Wheel Assembly Replacement
Unplug wires from Direct Spark Ignition DSI module
LINT BOX / BLOWER ASSEMBLY REMOVAL continued
Service Procedures for the Model 20 Dryers
Exhaust Temperature Probe
Safety
Door Switch
Page 1
Image 1
Service Procedures
for the Model 20 Dryers
(AD-20,
SL20, CG20, D20, and
STI-8
Dryers GEN II)
ADC Part No. 450261
Page 2
Page 1
Image 1
Page 2
Contents
AD-20, SL20, CG20, D20, and STI-8 Dryers GEN
Service Procedures for the Model 20 Dryers
POUR VOTRE SÉCURITÉ
FOR YOUR SAFETY
“IMPORTANT NOTE TO PURCHASER”
Retain This Manual in a Safe Place for Future Reference
FOR YOUR SAFETY
Table of Contents
LOWER FRONT PANEL REMOVAL
Part Locations and Removal
UPPER FRONT PANEL REMOVAL
Unplug wires from Direct Spark Ignition DSI module
LINT BOX / BLOWER ASSEMBLY REMOVAL
BACK GUARD REMOVAL
Remove all facing visible screws
LINT BOX / BLOWER ASSEMBLY REMOVAL continued
OVEN REMOVAL
GAS VALVE REMOVAL
TUMBLER SUPPORT WHEEL ASSEMBLY REPLACEMENT
EXAMPLES
TUMBLER ALIGNMENT
DOOR SWITCH
Electrical Component Locations
Door Switch
ELECTRICAL PANEL
DIRECT SPARK IGNITION DSI MODULE
FIRE SUPPRESSION SYSTEM ITEMS AND SAIL SWITCH
FLAME-PROBE
FLAME-PROBE POSITIONING
ROTATION SWITCH
EXHAUST PROBE, EXHAUST HI-LIMIT, AND LINT DRAWER SWITCH
Exhaust Hi-Limit Switch
Exhaust Temperature Probe
REQUIRED ITEMS
Belt Installation
Pull the belt up through the tumbler felt until there is enough belt to begin to loop the belt around the tumbler Fig. 7 and 8. Tape the belt to the outside of the tumbler with duct tape approximately 2-inches from the outside edge of the tumbler Fig. 9. Rotate the tumbler slowly in the clockwise direction, while pulling the end of the belt to the right side of the dryer. Continue to rotate the tumbler clockwise and proceed to tape the belt to the outside of the tumbler occasionally, to aid in holding the belt in place Fig
PLACING THE BELT BACK ON THE MOTOR SHEAVE
ADC Part No. 450261 2 - 09/15/05