Pull the belt up through the tumbler felt until there is enough belt to begin to loop the belt around the tumbler (Fig. 7 and 8). Tape the belt to the outside of the tumbler with duct tape approximately 2-inches from the outside edge of the tumbler (Fig. 9). Rotate the tumbler slowly in the clockwise direction, while pulling the end of the belt to the right side of the dryer. Continue to rotate the tumbler clockwise and proceed to tape the belt to the outside of the tumbler occasionally, to aid in holding the belt in place (Fig. 10).
FIG. 7 | FIG. 8 | FIG. 9 |
Guide the belt over the top of the front right tumbler roller, while continuing to turn the tumbler clockwise (Fig. 11). The end will pass between the top of the lint box and the tumbler. Guide the belt over the top of the front left roller (Fig. 12).
FIG. 10 | FIG. 11 | FIG. 12 |
Continue to turn the tumbler clockwise while feeding the belt out of the tumbler, until only a few inches are left in the tumbler. Pull the remaining belt out of the tumbler into the area above the tumbler, until only a few inches remain in the tumbler (Fig. 13).
FIG. 13 | FIG. 14 |
14 | American Dryer Corp. |
