American Dryer Corp ML-130 II - page 6

SECTION VI

ROUTINE MAINTENANCE ............................................................................44

A. Cleaning ................................................................................................................................... 44

B. Adjustments ............................................................................................................................. 46

C. Lubrication............................................................................................................................... 46

SECTION VII

DATA LABEL INFORMATION........................................................................ 47

A. Data Label ...............................................................................................................................47

SECTION VIII

REVERSING TIMER SPIN/DWELL ADJUSTMENTS.................................. 49

SECTION IX

PROCEDURE FOR FUNCTIONAL CHECK OF REPLACEMENT

COMPONENTS ................................................................................................50

SECTION X

BURNER AND BASKET (TUMBLER)/LINT CHAMBER

MANUAL RESET HI-LIMIT INSTRUCTIONS ..............................................53

Gas Models Only.............................................................................................................................. 53

Electric or Steam Models Only ..........................................................................................................54

Contents

Main ML-130 II (HSI) Installation Manual Retain This Manual In A Safe Place For Future Reference ML-130 II Important Page Page Table of Contents Page SECTION I IMPORTANT INFORMATION IMPORTANT: The dryer must be transported and handled in an upright position at ALL times. A. RECEIVING AND HANDLING B. SAFETY PRECAUTIONS Page SECTION II SPECIFICATIONS/COMPONENT IDENTIFICATION A. SPECIFICATIONS Gas Electric Steam NOTE:Operating height of steam dryer is 89-inches (226.1 cm). Specifications MLG-130 II (GAS) MLE-130 II (ELECTRIC) MLS-130 II (STEAM) B. COMPONENT IDENTIFICATION Page SECTION III INSTALLATION PROCEDURES A. LOCATION REQUIREMENTS IMPORTANT: The dryer must be installed on noncombustible floors only. IMPORTANT: Dryer should be located where a minimum amount of exhaust duct will be necessary. B. UNPACKING/SETTING UP IMPORTANT: The dryer must be transported and handled in an upright position at ALL times. WARNING THIS EXHAUST DUCT TRANSITION PIECE MUST BE INSTALLED FIRST! C. DRYER ENCLOSURE REQUIREMENTS D. FRESH AIR SUPPLY REQUIREMENTS E. EXHAUST REQUIREMENTS Page Page Page Page Page F. ELECTRICAL INFORMATION ML-130 II Reversing, 3 (GAS) ML-130 II Reversing, 3 (STEAM) ELECTRICAL SERVICE SPECIFICATIONS (PER DRYER) MLE-130 II (72 Kw Electric) Reversing, 3 ELECTRICAL SERVICE SPECIFICATIONS (PER DRYER) SERVICE VOLTAGE PHASE WIRE OVEN SIZE (Kw) SERVICE MLE-130 II (80 Kw Electric) Reversing, 3 ELECTRICAL SERVICE SPECIFICATIONS (PER DRYER) VOLTAGE PHASE OVEN SIZE (Kw) SERVICE APPROX. AMP DRAW NOTE: A CIRCUIT SERVICING EACH DRYER MUST BE PROVIDED. Page G. GAS INFORMATION TYPE OF GASLiquid Propane TYPE OF GAS Page Page H. STEAM INFORMATION Operating Steam Pressure Page COMPRESSED AIR SUPPLYAIR PRESSUR E Normal 80 PSI 5.52 bars Minimum Supply 70 PSI 4.83 bars Maximum Supply 90 PSI 6.21 bars Page I. PREPARATION FOR OPERATION J. PREOPERATIONAL TESTS Page K. SHUT DOWN INSTRUCTIONS L. OPERATING INSTRUCTIONS Page SECTION IV SERVICE/PARTS INFORMATION A. SERVICE B. PARTS SECTION V WARRANTY INFORMATION A. RETURNING WARRANTY CARDS B. WARRANTY C. RETURNING WARRANTY PARTS Page SECTION VI ROUTINE MAINTENANCE A. CLEANING SUGGESTED CLEANING SCHEDULE Page B. ADJUSTMENTS C. LUBRICATION Page Page SECTION VIII REVERSING TIMER SPIN/DWELL ADJUSTMENTS TIMING LEGEND SECTION IX PROCEDURE FOR FUNCTIONAL CHECK OF REPLACEMENT COMPONENTS Page Page SECTION X BURNER AND BASKET (TUMBLER)/LINT CHAMBER I M P O R T A N T FOR TIMER OR PHASE 5 WITHOUT HEAT FAULT (GAS MODELS ONLY) IMPORTANT I M P O R T A N T FOR TIMER OR PHASE 5 WITHOUT HEAT FAULT (ELECTRIC or STEAM MODELS ONLY) IMPORTANT