American Dryer Corp ML-96HS

Illus. No. Description

1Electrical Service Connections

2Top Console

3Heating Unit

4Relay/Wiring Box

5Data Label and Installation Label

6Air Connection

7Exhaust Transition Piece

8Optional Exhaust Damper Assembly - if damper option was purchased at time dryer order was

placed, the damper must be installed at the time of dryer

installation. If damper option was purchased, the damper is

shipped inside the dryer tumbler (basket)

2. Dryer Rear View

Contents

Main ML-96HS Installation Manual Retain This Manual In A Safe Place For Future Reference ML-96 HS Important Page Page Table of Contents 2 SECTION I IMPORTANT INFORMATION A. RECEIVING and HANDLING B. SAFETY PRECAUTIONS Page SECTION II SPECIFICATIONS/COMPONENT IDENTIFICATION GAS A. SPECIFICATIONS Page B. COMPONENT IDENTIFICATION Page 9 SECTION III IMPORTANT:Dryer should be located where a minimum amount of exhaust duct will be necessary. INSTALLATION PROCEDURES A. LOCATION REQUIREMENTS B. UNPACKING/SETTING UP Page C. DRYER ENCLOSURE REQUIREMENTS D. FRESH AIR SUPPLY E. EXHAUST REQUIREMENTS Page Page Page F. ELECTRICAL INFORMATION MLG-96HS ELECTRICAL SERVICE SPECIFICATION S (PER DRYER)* Page G. GAS INFORMATION 22 2. Technical Gas Data a. Gas Specifications T Natural Liquid Propane L.P. T Page H. PREPARATION FOR OPERATION AND START-UP I. PREOPERATIONAL TESTS J. OPERATING INSTRUCTIONS Page SECTION IV SERVICE and PARTS INFORMATION A. SERVICE B. PARTS SECTION V WARRANTY INFORMATION A. RETURNING WARRANTY CARD(S) B. PARTS C. RETURNING WARRANTY PARTS Page SECTION VI ROUTINE MAINTENANCE A. CLEANING B. ADJUSTMENTS C. LUBRICATION SECTION VII PROCEDURE FOR FUNCTIONAL CHECK OF REPLACEMENT COMPONENTS Hot Surface Ignition (HSI) System