SECTION VIII

PROCEDURE FOR FUNCTIONAL CHECK

OF REPLACEMENT COMPONENTS

1.Microprocessor (computer) Board

a.Upon completing installation of the replacement microprocessor (computer) board, reestablish power to the dryer.

b.Start the drying cycle by pressing any of the preset cycles in letters A-F.

c.Verify that the motor(s) and the heat indicator dots, in the microprocessor (computer) L.E.D. (light emitting diode) display are on. (Refer to the illustration below.)

1)Tumbler (Basket) in Forward Mode (clockwise [CW]) indicator

2)Tumbler (Basket) in Reverse Mode (counterclockwise [CCW]) indicator

3)Heat on indicator

4)On indicator (dryer is in Operation Mode)

5)Air Jet indicator

37

Page 41
Image 41
American Dryer Corp MLG-130DR (HSI) installation manual Procedure for Functional Check Replacement Components