American Power Conversion AP7902 AP7911 quick start Mounting options

How to Install the Rack PDU

Attach cords to the tray Attach a cord to the tray by looping the cord and securing it to the tray, using a wire tie (provided). Cords from both banks of outlets may be secured to the bottom tray, or you may attach an additional tray (shown on the preceding page) to secure cords from the top bank of outlets. Make sure the cords that are attached to the upper tray do not interfere with the operation of the circuit breakers.

Each cord must be secured to the tray so that you can unplug it from the Rack PDU without removing the wire tie.

Note

Mounting options	You can install the Rack PDU in one of two ways: flush with the rack, or
	recessed to allow the use of the cord retention bracket. To mount the
	Rack Rack PDU horizontally in a NetShelter® or any other standard
	EIA-310 rack or enclosure:
	1. Attach the mounting brackets to the Rack PDU, using the flat-head
	screws (provided).
		Some enclosures may require you to recess the Rack
		PDU so that the back doors of the enclosure will close
	Note	when other devices are plugged in to the Rack PDU.

For placement flush-to-rack: use four flat-head screws (provided) for each bracket.

4 Switched Rack PDU Installation and Quick Start