American Standard 0163.060, 0165.060 dimensions Solar Bath for Above Floor Rough Installation

BARRIER FREE

SOLAR™ BATH

ENAMELED STEEL

SOLAR BATH™ FOR ABOVE FLOOR ROUGH INSTALLATION

❏0163.060 Right hand outlet

❏0165.060 Left hand outlet

Product Features:

•Acid resisting, enameled steel construction

•One-piece bath

•Integral apron

•For above-floor rough installations

•End drain outlet

•Full slip-resistant pattern

•Straight tiling flange

•Fully-bonded support pad

Nominal Dimensions:

1524 x 762 x 445mm (60" x 30" x 17-1/2")

Bathing Well Dimensions:

1346 x 610 x 337mm (53" x 24" x 13-1/4")

Compliance Certifications -

Meets or Exceeds the Following Specifications:

•ASME A112.19.4 for Enameled Steel Plumbing Fixtures

•ASTM F-462 for Slip-resistant Bathing Facilities

To Be Specified:

❏Color:

❏Bath Faucet*:

❏Faucet Finish:

❏Drain: 1583.470

* See faucet section for additional models available

NOTE: NO CONCEALED			OPTIONAL TO FINISHED TO FINISHED
			FLOOR (USALLY BETWEEN 1651 to
PIPING FURNISHED
			1981mm ( 65" & 78')			1/2 S.P.S. OR 1/2"
			SHOWER 1/2" S.P.S.			C.W.T. SUPPLIES
		711mm			203mm	76mm
		(28)			(8)	(3)
				19mm
		FINISHED		(3/4)	197mm
		WALL
					(7-3/4)
C/L OF SHOWER CURTAIN ROD					C/L OF DRAIN
(USUALLY 1930mm (76")
FROM FIN. FLOOR)
C/L OF VALVES		102mm		1524mm	FINISHED
					WALL
(44mm [1-3/4"]
		(8)		(60)
DIA. HOLES)		102
		(4)			365mm
	SPOUT				(14-3/8)
305mm
	1/2" S.P.S.
(12)
	102 (4)			FINISHED
				WALL
ROUGH				445mm
				(17-1/2)
FLOOR					19mm
					762mm	(3/4)
DRAIN SHOE		95mm			(30)

4PLUMBER NOTE:

SUMP PAD	PROVIDE SUITABLE FULL LENGTH
	SUPPORT AT THIS POINT.

MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES AND ANSI A117.1 REQUIREMENTS FOR ACCESSIBLE AND USEABLE BUILDING FACILITIES-CHECK LOCAL CODES. INSTALL WITH SEAT AT HEAD END.

NOTES:

0165.060 LEFT HAND OUTLET (SHOWN).

0163.060 RIGHT HAND OUTLET (REVERSE DIMENSIONS). SHOWN WITH POP-UP C.D. & O.

FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY. CONCEALED PIPING NOT INCLUDED.

IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.4. These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided leaflet.

	H161
© 2008 AS America Inc.		Revised 2/08