American Standard 2064.4 Install Handles, Test Installed Fitting, Check Drain Connections

11 INSTALL HANDLES
Push ADAPTER (1) on VALVE STEM (2), so that the hole of the
ADAPTER (1) without a spline is facing up. See figure "A". Tighten		THREAD ON
STEM SCREW (3) to secure ADAPTER (1).	4	TO DECK
Find correct position of LEVER HANDLE ASSEMBLY (4) by adjusting		ADAPTER
male teeth on ADAPTER (1) to female teeth in HANDLE (4).	TOP
Thread LEVER HANDLE ASSEMBLY (4) onto ESCUTCHEON (5)		1
until snug against mounting surface.		3
Figure "A"
		2
SPLINE END DOWN		5

12 TEST INSTALLED FITTING

With HANDLES (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks.

Operate both HANDLES (1) to flush water	1
lines thoroughly.
Rotate TRANSFER VALVE (5) from rim wash to
spray several times to check operation.

OUTLINE OF BIDET

3

1

13 CHECK DRAIN CONNECTIONS

Pull up POP-UP KNOB (3) and fill Bidet with water. Check

that DRAIN STOPPER (4) makes a good seal and retains4 water in Bidet. If STOPPER (4) does not seal properly,

please refer to “Troubleshooting Guide” in these instructions.

Push POP-UP KNOB (3) down and check all drain connections and "P" trap for leaks. Tighten

if necessary.

2

2

SPRAY

14 CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.

15			SERVICE
	To change direction of handle rotation,
	proceed as follows:			UNTHREAD
		Turn valve to OFF position.			1
		Thread counter-clock wise HANDLE BASE (1) to remove
		HANDLE ASSEMBLY (2) from ESCUTCHEON BASE (3).
		Use a flat blade screw driver to remove SPRING CLIP (4).
		Lift STOP WASHER (5), turn 90˚		and replace.	5
		Replace SPRING CLIP (4).
		Reinstall HANDLE ASSEMBLY (2).

If spout drips, operate handles several times from OFF 3 to ON position. Do not force - handles turn only 90˚.

2

VALVE

90˚

4

M968924 Rev.1.3