American Standard 2097.012 installation instructions NEW SAVONA 1.6 GPF ONE-PIECE TOILET, U S E

INSTALLATION INSTRUCTIONS

NEW SAVONA 1.6 GPF ONE-PIECE TOILET

Model 2097.012

Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.

!CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!

NOTE: Pictures may not exactly define contour of china and components.

RECOMMENDED TOOLS AND MATERIALS

Putty Knife	Regular Screwdriver	Adjustable Wrench	Sealant	Tape Measure
Hacksaw	Wax Ring/Gasket	Flexible Supply Tube	Closet Bolts	Carpenters Level

1REMOVE OLD TOILET

a.Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.

b.Disconnect and remove supply line. NOTE: If replacing valve, first shut off main water supply!

c.Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.

d.Remove closet bolts from flange and clean away old wax, putty, etc. from base area. NOTE: Mounting surface must be clean and level before new toilet is installed!

U S E

2 ROUGHING-IN DIMENSIONS:

NOTE: Distance from wall to closet flange centerline must be as listed below:

		FINISHED WALL
			736mm		413mm
					(16-1/4)
			(29)
		23mm			355mm
		(7/8)
					(14)
		176mm
					C/L
		(7)
			C/L OF SEAT POST
			HOLES 140mm
			(5-1/2) CTR'S.			767mm
79mm 1/8)-(7			473mm		388mm	(30-1/4)
			(18-1/2)		(15-5/16)
						384mm
				FINISHED		(15)
			13mm
				FLOOR
			(1/2)
140mm	1/2)-(5
		203mm			305mm
		(8)
					(12)
		305mm	343mm		C/L OF SUPPLY
		(12)	(13-1/2)		AS REQUIRED

3

CLOSET

FLANGE

A

CLOSET

BOLTS

INSTALL CLOSET BOLTS

Install closet bolts in flange channel, turn 90°, and slide into place 6" (152 mm) apart and parallel to wall.

V E F O R F U T U R E

4

WAX RING

SEALANT

INSTALL WAX SEAL

Invert toilet on floor (cushion to prevent damage), and install wax ring evenly around waste flange (horn), with tapered end of ring facing toilet. Apply a thin bead of sealant around toilet base.

5

NUT

WASHER

THIS SIDEUP

BOLT

FLANGE

POSITION TOILET ON FLANGE

a.Unplug floor waste opening and install toilet on closet flange so bolts project through mounting holes.

b.Loosely install retainer washers and nuts. Side of washers marked "THIS

SIDE UP" must face up!

S A

P r o d u c t n a m e s l i s t e d	h e r e i n a r e t r a d e m a r k s o f A S A m e r i c a , I n c .	7301387-100
© A S A m e r i c a , I n c . 2 0 0 9