INSTALLATION AND FRAMING INSTRUCTIONS
The variety of installations possible for this whirlpool may require framing procedures other than those shown. Locate studs as required. Ensure
NOTE: The apron should not be used as the primary access opening.
1.Position the whirlpool into the installation opening and level the deck, shimming the integral support feet as necessary.
2.Install drain components to the whirlpool following the manufacturers instructions. Before replacing your whirlpool for final installation, be certain that an opening has been provided in the
3.Replace whirlpool and
TYPICAL PIER TYPE INSTALLATION
CUTOUT DIMENSIONS
AS
DESIRED *
1 9 - 1 / 2
( 4 9 5 m m )
*
12
(305mm)
MINIMUM DIMENSION
FOR FACE TO FACE
OF SUBSTRUCTURE
DRAIN END OF
WHIRLPOOL
* 889mm
(35)
*749mm | 451mm | |
TYP. | ||
|
AS DESIRED
2 4
*10mm (3/8)
* 1784mm
( 6 1 0 m m )
* 435mm |
UNLESS AN ACCESS OPENING OF AT LEAST 12" X 24" (305 X 610MM) IS PROVIDED, WARRANTY SERVICE WILL NOT BE PERFORMED.
*SEE CUTOUT TEMPLATE PROVIDED
* 870mm |
(2) |