American Standard 3475.300 Pop-Updrain, Remove Flange, Install Drain From, Below Fixture, Fig. A

3 POP-UP DRAIN

Remove CLEAR PLASTIC COVER (1).

Remove CARDBOARD SPACER (2) from under DRAIN POP-UP (3).

Tighten TAILPIECE (4) on DRAIN BODY before installing DRAIN BODY. Fig. B.

Fig. A.

1

3

2

Fig. B.

DRAIN

BODY

7

4 REMOVE FLANGE

Thread FLANGE (1) counter-clockwise and remove FLANGE (1) and FOAM GASKET (2) from drain

body. Fig. A.

Thread LOCKNUT (3) clock-wise to bottom of drain body. Push GASKET (4) down against LOCKNUT (3). Fig. B.

Fig. A.

1

2

Fig. B.

4

3

5	INSTALL DRAIN FROM
	BELOW FIXTURE

From under side of BIDET install DRAIN BODY (1) up through drain outlet.

Note: No plumber’s putty or caulk is required.

The CABLE ATTACHMENT POINT (2) must face towards the rear of the BIDET.

Install FOAM GASKET (3) and FLANGE (4) onto drain body from above BIDET and tighten FLANGE (4) firmly.

6

4

3

DRAIN

OUTLET

1

2

TIGHTEN LOCKNUT

Tighten LOCKNUT (1) firmly with Adjustable Wrench or Channel Locks.

1

7 FLANGE GASKET

Check DRAIN FLANGE in BIDET to ensure that WHITE FOAM GASKET (1) is fully compressed and not visible.

Fig. A.

POP-UP ROD ASSEMBLY

Insert LIFT ROD GUIDE (1) and CABLE CONNECTOR (2) through rear hole, making sure SEAL WASHER (3) is properly seated. Fig. B.

From below slip slot in MOUNTING NUT (4) over CABLE (5). Thread NUT (4) onto lift rod guide shank to secure ROD GUIDE (1) to bidet. Hand tighten only. Fig. B.

Fig. A.

DRAIN

FLANGE

1 WHITE FOAM

GASKET

NOT VISIBLE

2

Fig. B. 1

3

SLOTTED

MOUNTING

NUT

4

ILLUSTRATION

SHOWN LESS2 VALVES

M968795Rev. 1 . 1